What are the requirements of DC socket manufacturers on the use standard? Let's give you a detailed introduction.
DC socket manufacturers have the highest production requirements for the main products. In many products, DC socket manufacturers only need high-quality mainstream products to have a higher strength than other manufacturers. Therefore, we are impeccable about the strength and quality of our main products. In many products, we should also pay attention to the manufacturer's information when selecting. If we don't know about DC socket products or some manufacturers, our large number of products will be very passive and may be lost at any time. Before selection, understand the DC socket, including the technical requirements and standards of DC socket, etc., and pay attention to the following:
1. Observe whether the marks on the plug and socket are complete, including the DC socket manufacturer's title, standard model, rated current value, power supply property symbols and relevant warning words, etc.
2. Select the corresponding plug and socket according to the power of the appliance. Do not plug the two kinds of household appliances with higher power into the same socket;
3. Do not plug the household appliances with high power into the sockets with low rated current;
4. After the plug is inserted into the socket, it should be touched tightly, without the feeling of looseness, and can be pulled out without too much effort;
General standard for sockets with general characteristics:
Introduction of DC socket manufacturer's requirements on use and standards
1. Rated value: dc30v / 0.1A.
2. Working temperature: - 10 ℃ ~ 70 ℃.
3. Storage temperature: - 20 ℃ ~ 80 ℃.
4. The normal test conditions (measurement not specifically stated) are given to the qualified rate or above.
When choosing DC power socket, reliability is always the priority. We must remember that the quality is the key. We must choose a good brand and trustworthy DC socket manufacturer to avoid buying inferior products.