Introduction to Installation Method of Button Switch
Release time：2019-06-25 Clicks： Click
We have learned how to install the button switch, so what should we do in disassembly? Let's give you a detailed introduction.
How should the button switch be disassembled? What is the method of attention? The manufacturer of the button switch below tells you how to disassemble it.
How to disassemble the switch button? First, prepare the tool, a small type screwdriver and a large cross type screwdriver. The first step is to open the cover of the wall switch first. Generally, under the cover, we can see an opening of about 0.5 cm. We can open the cover from here. Then take out the small screwdriver in the tool we prepared before and gently tilt the cover plate forward from the opening, and then it's easy to take it off.
After opening the cover, we still can't see the fixed bolt. We need to remove the switch panel, and then use a small screwdriver to carefully pry the switch panel forward, so that the switch panel itself will fall off. Then the second switch panel can be removed according to the above method. Then you can see the two fixed bolts on the mounting frame. The whole wall switch can be removed by rotating counter-clockwise with the cross screwdriver. After removal, replace the new wall switch according to the original wiring method. Usually, the wiring column of L is connected to the line, and the line of L1 or L2 is connected to the light line.
When the switch is disassembled, remove the outer waterproof cover first. We can see a small gap on the side of the waterproof cover. We can remove the waterproof cover with a small screwdriver and a hard knock. When the mask is removed, you can see that there are screws on both sides. Turn on the screw switch and it will open naturally. After opening the switch panel, we need to replace the new one. Just remove the wires from the old switch panel and reset them to the corresponding place of the new switch panel. Generally, there are at least five wires on the switch of Baby Bath, two wires for heating, one for ventilation, one for lighting and one for fire. Let's change all five wires to the new switch panel and then install them according to the original steps. Finally, after the installation, we can open the switch and try it out.